Genel Bakış
HSD3 series high-end synchronous AC servo driver adopt the advanced control algorithm, support mainstream protocol such as MODBUS, CANOPEN,EtherCAT, MECHATROLINK which can realize speed and accurate position control.
With intelligent power module (IPM) and other latest technology design, simple operation, high reliability, small size, easy to install.
Cover a big range of servo motor, support three phase AC220V and 380V power supply.
Support 17bit increamental and 17bit/23bit absolute type encoder.
This servo driver has mature servo technology and the highest cost perform
|
Özellikler
1.Main circuit power supply: Three-phase AC220V, 50/60Hz; Three-phase AC380V, 50/60Hz;
2. Control mode: Position control, JOG operation, speed contact, etc.
3. Encoder feedback:
Ordinary incremental encoder: 2500 lines incremental standard type, 2500 lines incremental saving line type.
Serial encoder：17 bits incremental type encoder, 17 bits/23 bits absolute value encoder.
4. Communication: Standard MODBUS, CANOPEN, EtherCAT, MECHATROLINK.
5. Speed control range: 1:10000（The lower limit of the speed control range is in the stable running without crawling at the rated load）;
6. Digital Input terminal: Photoelectric coupling isolation, functional programmable, can realize servo ON (/ S - ON), P action (/P - CON), not forward the side drive (P - OT), not reverse side drive (N-OT), alarm reset (/ALM-RST), forward side torque limit (/P-CL), reverse side torque limit (/N-CL), zero position deviation (/CLR), internal set speed switch and so on
7. Digital output terminal: functional programmable, can realize servo alarm (ALM), position completion (/COIN), speed consistency inspection (/V-CMP), servo motor rotation detection (/TGON), servo readiness (/S-RDY), torque limit detection (/CLT), brake (/BK), encoder zero output (PGC).
8. Over travel (OT) prevention function: Dynamic brake (DB) stopping, decelerate stopping, or free running stop when it is at P-OT, N-OT input action
9.Protection function: Over current, overvoltage, under voltage, overload, over speed, regeneration fault, encoder feedback error, etc.
|
